281-489-7844
banner

RELIABILITY = SAFETY PLUS

Reliability Is The Key Word For Our Safety Shower And Eye Wash Alarm Switch. These Switches Are Designed For Use In Hostile Environments Where Protection Is Needed Against Corrosive Gases, Salt Sprays, High Humidity, Acids, Caustics, Brine Solutions, And Other Harsh Conditions. Because This Switch Is Suitable For Microprocessor Input And Provides Millions Of Reliable, Trouble-Free Operations, You Can Be Immediately Aware Of Problems In The Field And Provide Quick Attention To Your Employees

about-img

Mercury Free Throw Down Switch

The Has-12787 Switch Consists Of A Molded Plastic Housing And A Replaceable Encapsulated Single Pole Double Throw Form “C” Switch. The Combination Of Hermetically Sealed Switch Contacts Protected By Epoxy Potting Compound And Water Tight Housing Assures Long Reliable Service In Spite Of Corrosive Gases, Water, Oils And Other Atmospheric Conditions. More Than Ten Million Operations Are Expected Even Under Severe Atmospheric Conditions.

Features

  • Low Cost
  • Simple Installation
  • Corrosion Resistant
  • Waterproof
  • Millions of Operations
  • Mercury Free
  • Safe for the Environment
  • Pollution Free
  • Hermetically Sealed
  • Not Critical to Vibration
  • PVC and Stainless Steel Construction
  • Resists Most Harsh Environments
  • Each Unit Pre-Tested
  • High Reliability
  • Easy to Maintain
  • Impervious to Water, Oil and Gases

"There's A Custom Switch for Every Application." TM

Specifications for Model No. HAS-12787

about-img

Specifications

  • Cable: 10 feet of 18 AWG Type TC, 3 conductor with PVC overall jacket rated 600 volts. 90 * C dry, 75* C wet, UL file #E69749, UL listed OSHA accepted.
  • Switch:
    Contact Rating: 3 amps DC or 100VA max.
    Contact Voltage: 0-28V DC or 0-120AC
    Contact arrangement: Single pole double throw
    Note: Use arc suppression network to extend life of switch.
  • Strain Relief: Fiberglass reinforced polyamid Liquid tight to 70 PSI
  • Hook: Stainless Steel (type 304)
  • Temperature: 167*F Max
  • Weight: 1(1/2lb)

Specifications for Model No. HAS-12787

Construction

The switch housing is molded PVC with a PVC (polyvinyl chloride) cable protruding. One end of the cable is permanently connected to the single pole double throw Form “C” switch and the entire assembly is epoxy encapsulated to form a water tight switch.

Caution: This switch must be installed and grounded
per National Electrical Code. Custom Switches ARE NOT intended to be used as a final safety device.

about-img